Kontron AT890X Full-Size CLI - Manual (Page 92)

Switching Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 2 - 58
01:80:C2:00:00:21, and FF:FF:FF:FF:FF:FF. The <
vlanid
> parameter must identify a
valid VLAN. You can create up to 100 static MAC filters.
Format macfilter
Mode Global Config
2.14.1.1 no macfilter
This command removes all filtering restrictions and the static MAC filter entry for the
MAC address
on the VLAN . The parameter must be
specified as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The parameter must identify a valid VLAN.
Format
no macfilter
Mode Global Config
2.14.2 macfilter addsrc
This command adds the interface to the source filter set for the MAC filter with the
MAC address of and VLAN of . The parameter must
be specified as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The
parameter must identify a valid VLAN.
Format macfilter addsrc
Mode Interface Config
2.14.2.1 no macfilter addsrc
This command removes a port from the source filter set for the MAC filter with the
MAC address of
and VLAN of . The parameter
must be specified as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The
parameter must identify a valid VLAN.
Format no macfilter addsrc
Mode Interface Config
2.14.3 macfilter addsrc all
This command adds all interfaces to the source filter set for the MAC filter with the
MAC address of
and . You must specify the
parameter as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The
parameter must identify a valid VLAN.
Format
macfilter addsrc all
Mode Global Config
2.14.3.1 no macfilter addsrc all
This command removes all interfaces to the source filter set for the MAC filter with the
MAC address of
and VLAN of . You must specify the
parameter as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The parameter must identify a valid VLAN.