Kontron AT890X Full-Size CLI - Manual (Page 250)

Management Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 6 - 8
outbound Telnet operational mode as ‘linemode’, where by default, the operational
mode is ‘character mode’. The noecho option disables local echo.
Format telnet [debug] [line] [noecho]
Modes Privileged EXEC
User EXEC
6.3.3 transport input telnet
This command regulates new Telnet sessions. If enabled, new Telnet sessions can be
established until there are no more sessions available. An established session remains
active until the session is ended or an abnormal network error ends the session.
NOTE: If the Telnet Server Admin Mode is disabled, Telnet sessions cannot
be established. Use the ip telnet server enable command to
enable Telnet Server Admin Mode.
Default enabled
Format
transport input telnet
Mode Line Config
6.3.3.1 no transport input telnet
Use this command to prevent new Telnet sessions from being established.
Format no transport input telnet
Mode Line Config
6.3.4 transport output telnet
This command regulates new outbound Telnet connections. If enabled, new outbound
Telnet sessions can be established until the system reaches the maximum number of
simultaneous outbound Telnet sessions allowed. An established session remains active
until the session is ended or an abnormal network error ends it.
Default enabled
Format transport output telnet
Mode Line Config
6.3.4.1 no transport output telnet
Use this command to prevent new outbound Telnet connection from being established.
Format
no transport output telnet
Mode Line Config
6.3.5 session-limit
This command specifies the maximum number of simultaneous outbound Telnet
sessions. A value of 0 indicates that no outbound Telnet session can be established.
Default 5
Format session-limit <0-5>