Kontron AT890X Full-Size CLI - Manual (Page 137)

AT8901/2/3 Routing Commands
Page 3 - 25 AT8901/2/3 CLI Reference Manual
Default enabled
Format
enable
Mode Router OSPF Config
3.7.2.1 no enable (OSPF)
This command sets the administrative mode of OSPF in the router to inactive.
Format no enable
Mode Router OSPF Config
3.7.3 ip ospf
This command enables OSPF on a router interface.
Default disabled
Format
ip ospf
Mode Interface Config
3.7.3.1 no ip ospf
This command disables OSPF on a router interface.
Format no ip ospf
Mode Interface Config
3.7.4 1583compatibility
This command enables OSPF 1583 compatibility.
NOTE: 1583 compatibility mode is enabled by default. If all OSPF routers in
the routing domain are capable of operating according to RFC 2328,
OSPF 1583 compatibility mode should be disabled.
Default enabled
Format 1583compatibility
Mode Router OSPF Config
3.7.4.1 no 1583compatibility
This command disables OSPF 1583 compatibility.
Format
no 1583compatibility
Mode Router OSPF Config
3.7.5 area default-cost (OSPF)
This command configures the default cost for the stub area. You must specify the area
ID and an integer value between 1-16777215.
Format area default-cost <1-16777215>
Mode Router OSPF Config