Kontron AT890X Full-Size CLI - Manual (Page 110)

Switching Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 2 - 76
Mode Global Config
2.18.6.1 no dos-control icmp
This command disables Maximum ICMP Packet Size Denial of Service protections.
Format
no dos-control icmp
Mode Global Config
2.18.7 show dos-control
This command displays Denial of Service configuration information.
Format show dos-control
Mod Privileged EXEC
SIPDIP Mode May be enabled or disabled. The factory default is disabled.
First Fragment Mode May be enabled or disabled. The factory default is disabled.
Min TCP Hdr Size <0-255> The factory default is 20.
TCP Fragment Mode May be enabled or disabled. The factory default is disabled.
TCP Flag Mode May be enabled or disabled. The factory default is disabled.
L4 Port Mode May be enabled or disabled. The factory default is disabled.
ICMP Mode May be enabled or disabled. The factory default is disabled.
Max ICMP Pkt Size <0-1023> The factory default is 512.
2.19 MAC Database Commands
This section describes the commands you use to configure and view information about
the MAC databases.
2.19.1 bridge aging-time
This command configures the forwarding database address aging timeout in seconds.
The
parameter must be within the range of 10 to 1,000,000 seconds.
Default 300
Format bridge aging-time <10-1,000,000>
Mode Global Config
2.19.1.1 no bridge aging-time
This command sets the forwarding database address aging timeout to the default value.
Format
no bridge aging-time
Mode Global Config
2.19.2 show forwardingdb agetime
This command displays the timeout for address aging. In an IVL system, the [fdbid |
all] parameter is required.