Kontron AT890X Full-Size CLI - Manual (Page 253)

AT8901/2/3 Management Commands
Page 6 - 11 AT8901/2/3 CLI Reference Manual
Remote Connection Login Timeout (minutes) This object indicates the number of
minutes a remote connection session is allowed to remain inactive
before being logged off. May be specified as a number from 1 to 160.
The factory default is 5.
Maximum Number of Remote Connection Sessions This object indicates the num-
ber of simultaneous remote connection sessions allowed. The factory
default is 5.
Allow New Telnet Sessions Indicates that new Telnet sessions will not be allowed
when set to no. The factory default value is yes.
6.4 Secure Shell (SSH) Command
This section describes the commands you use to configure SSH access to the switch.
Use SSH to access the switch from a remote management host.
NOTE: The system allows a maximum of 5 SSH sessions.
6.4.1 ip ssh
Use this command to enable SSH access to the system.
Default disabled
Format
ip ssh
Mode Privileged EXEC
6.4.1.1 no ip ssh
Use this command to disable SSH access to the system.
Format no ip ssh
Mode Privileged EXEC
6.4.2 ip ssh protocol
This command is used to set or remove protocol levels (or versions) for SSH. Either
SSH1 (1), SSH2 (2), or both SSH 1 and SSH 2 (1 and 2) can be set.
Default 1 and 2
Format
ip ssh protocol [1] [2]
Mode Privileged EXEC
6.4.3 ip ssh server enable
This command enables the IP secure shell server.
Default disabled
Format
ip ssh server enable
Mode Privileged EXEC