Kontron AT890X Full-Size CLI - Manual (Page 43)

AT8901/2/3 Switching Commands
Page 2 - 9 AT8901/2/3 CLI Reference Manual
Format
no spanning-tree hello-time
Mode Interface Config
2.2.9 spanning-tree max-age
This command sets the Bridge Max Age parameter to a new value for the common and
internal spanning tree. The max-age value is in seconds within a range of 6 to 40, with
the value being less than or equal to 2 x (Bridge Forward Delay - 1).
Default 20
Format
spanning-tree max-age <6-40>
Mode Global Config
2.2.9.1 no spanning-tree max-age
This command sets the Bridge Max Age parameter for the common and internal
spanning tree to the default value.
Format
no spanning-tree max-age
Mode Global Config
2.2.10 spanning-tree max-hops
This command sets the MSTP Max Hops parameter to a new value for the common
and internal spanning tree. The max-hops value is a range from 1 to 127.
Default 20
Format
spanning-tree max-hops <1-127>
Mode Global Config
2.2.10.1 no spanning-tree max-hops
This command sets the Bridge Max Hops parameter for the common and internal
spanning tree to the default value.
Format no spanning-tree max-hops
Mode Global Config
2.2.11 spanning-tree mst
This command sets the Path Cost or Port Priority for this port within the multiple
spanning tree instance or in the common and internal spanning tree. If you specify an
parameter that corresponds to an existing multiple spanning tree instance, the
configurations are done for that multiple spanning tree instance. If you specify 0
(defined as the default CIST ID) as the
, the configurations are done for the
common and internal spanning tree instance.
If you specify the cost option, the command sets the path cost for this port within a
multiple spanning tree instance or the common and internal spanning tree instance,
depending on the
parameter. You can set the path cost as a number in the
range of 1 to 200000000 or auto. If you select auto the path cost value is set based on
Link Speed.