Kontron AT890X Full-Size CLI - Manual (Page 236)

Utility Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 5 - 38
Format
no option
Mode DHCP Pool Config
5.9.16 ip dhcp excluded-address
This command specifies the IP addresses that a DHCP server should not assign to
DHCP clients. Low-address and high-address are valid IP addresses; each made up of
four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
Default none
Format
ip dhcp excluded-address [highaddress]
Mode Global Config
5.9.16.1 no ip dhcp excluded-address
This command removes the excluded IP addresses for a DHCP client. Low-address and
high-address are valid IP addresses; each made up of four decimal bytes ranging from
0 to 255. IP address 0.0.0.0 is invalid.
Format no ip dhcp excluded-address [highaddress]
Mode Global Config
5.9.17 ip dhcp ping packets
Use this command to specify the number, in a range from 2-10, of packets a DHCP
server sends to a pool address as part of a ping operation. By default the number of
packets sent to a pool address is 2, which is the smallest allowed number when sending
packets. Setting the number of packets to 0 disables this command.
Default 2
Format ip dhcp ping packets <0,2-10>
Mode Global Config
5.9.17.1 no ip dhcp ping packets
This command prevents the server from pinging pool addresses and sets the number of
packets to 0.
Default 0
Format
no ip dhcp ping packets
Mode Global Config
5.9.18 service dhcp
This command enables the DHCP server.
Default disabled
Format
service dhcp
Mode Global Config