Kontron AT890X Full-Size CLI - Manual (Page 255)

AT8901/2/3 Management Commands
Page 6 - 13 AT8901/2/3 CLI Reference Manual
Mode Privileged EXEC
Administrative Mode This field indicates whether the administrative mode of SSH is
enabled or disabled.
Protocol Level The protocol level may have the values of version 1, version 2 or both
versions 1 and version 2.
Connections This field specifies the current SSH connections.
6.5 User Account Commands
This section describes the commands you use to add, manage, and delete system users.
FASTPATH has two default users: admin and guest. The admin user can view and
configure system settings, and the guest user can view settings.
NOTE: You cannot delete the admin user, and there is only one user allowed
with read/write privileges. You can configure up to five read-only
users on the system.
6.5.1 users name
This command adds a new user account, if space permits. The account can
be up to eight characters in length. You can use alphanumeric characters as well as the
dash (‘-’) and underscore (‘_’). You can define up to six user names.
NOTE: The is not case sensitive when you add and delete users,
and when the user logs in. However, when you use the to
set the user password, authentication, or encryption, you must enter
the
in the same case you used when you added the user.
To see the case of the , enter the
show users
command.
Format
users name
Mode Global Config
6.5.1.1 no users name
This command removes a user account.
Format no users name
Mode Global Config
NOTE: You cannot delete the “admin” user account.
6.5.2 users passwd
Use this command to change a password. Passwords are a maximum of eight
alphanumeric characters. If a user is authorized for authentication or encryption is
enabled, the password length must be at least eight alphanumeric characters. The
password is case sensitive. When you change a password, a prompt asks for the old
password. If there is no password, press enter. You must enter the
in the
same case you used when you added the user. To see the case of the , enter
the
show users
command.
Default no password