Kontron AT890X Full-Size CLI - Manual (Page 57)

AT8901/2/3 Switching Commands
Page 2 - 23 AT8901/2/3 CLI Reference Manual
2.3.17.1 no protocol group
This command removes the from this protocol-based VLAN group that is
identified by this .
Format no protocol group
Mode VLAN Config
2.3.18 protocol vlan group
This command adds the physical interface to the protocol-based VLAN identified by
. You can associate multiple interfaces with a group, but you can only
associate each interface and protocol combination with one group. If adding an
interface to a group causes any conflicts with protocols currently associated with the
group, this command fails and the interface(s) are not added to the group.
You should create the referenced VLAN before you create the protocol-based VLAN
except when you configure GVRP to create the VLAN.
Default none
Format
protocol vlan group
Mode Interface Config
2.3.18.1 no protocol vlan group
This command removes the interface from this protocol-based VLAN group that is
identified by this .
Format no protocol vlan group
Mode Interface Config
2.3.19 protocol vlan group all
This command adds all physical interfaces to the protocol-based VLAN identified by
. You can associate multiple interfaces with a group, but you can only
associate each interface and protocol combination with one group. If adding an
interface to a group causes any conflicts with protocols currently associated with the
group, this command will fail and the interface(s) will not be added to the group.
You should create the referenced VLAN before you create the protocol-based VLAN
except when you configure GVRP to create the VLAN.
Default none
Format
protocol vlan group all
Mode Global Config
2.3.19.1 no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is
identified by this
.
Format
no protocol vlan group all
Mode Global Config