Kontron AT890X Full-Size CLI - Manual (Page 187)

AT8901/2/3 Quality of Service (QoS) Commands
Page 4 - 21 AT8901/2/3 CLI Reference Manual
Policy Name The name of this policy.
Type
The policy type (Only inbound policy definitions are supported for
this platform.)
The following information is repeated for each class associated with this policy (only
those policy attributes actually configured are displayed):
Assign Queue Directs traffic stream to the specified QoS queue. This allows a traffic
classifier to specify which one of the supported hardware queues are
used for handling packets belonging to the class.
Class Name The name of this class.
Committed Burst Size (KB) This field displays the committed burst size, used in
simple policing.
Committed Rate (Kbps) This field displays the committed rate, used in simple polic-
ing,
Conform Action The current setting for the action taken on a packet considered to
conform to the policing parameters. This is not displayed if policing is
not in use for the class under this policy.
Conform COS This field shows the CoS mark value if the conform action is set-cos-
transmit.
Conform DSCP Value This field shows the DSCP mark value if the conform action
is set-dscp-transmit.
Conform IP Precedence Value This field shows the IP Precedence mark value if the
conform action is set-prec-transmit.
Drop Drop a packet upon arrival. This is useful for emulating access control
list operation using DiffServ, especially when DiffServ and ACL can-
not co-exist on the same interface.
Mark CoS Denotes the class of service value that is set in the 802.1p header of
inbound packets. This is not displayed if the mark cos was not speci-
fied.
Mark IP DSCP Denotes the mark/re-mark value used as the DSCP for traffic match-
ing this class. This is not displayed if mark ip description is not speci-
fied.
Mark IP Precedence Denotes the mark/re-mark value used as the IP Precedence for
traffic matching this class. This is not displayed if mark ip precedence
is not specified.
Mirror Copies a classified traffic stream to a specified egress port (physical
port or LAG). This can occur in addition to any marking or policing
action. It may also be specified along with a QoS queue assignment.
This field does not display on Broadcom 5630x platforms.
Non-Conform Action The current setting for the action taken on a packet considered
to not conform to the policing parameters. This is not displayed if
policing not in use for the class under this policy.
Non-Conform COS This field displays the CoS mark value if the non-conform action
is set-cos-transmit.