Kontron AT890X Full-Size CLI - Manual (Page 153)

AT8901/2/3 Routing Commands
Page 3 - 41 AT8901/2/3 CLI Reference Manual
Subtotal Number of entries for the identified area.
Total Number of entries for all areas.
3.7.46 show ip ospf interface
This command displays the information for the IFO object or virtual interface tables.
Format
show ip ospf interface {<unit/slot/port> | loopback back-id>}
Modes Privileged EXEC
User EXEC
IP Address Represents the IP address for the specified interface.
Subnet Mask A mask of the network and host portion of the IP address for the OSPF
interface.
OSPF Admin Mode States whether OSPF is enabled or disabled on a router inter-
face.
OSPF Area ID Represents the OSPF Area Id for the specified interface.
Router Priority A number representing the OSPF Priority for the specified interface.
Retransmit Interval A number representing the OSPF Retransmit Interval for the
specified interface.
Hello Interval A number representing the OSPF Hello Interval for the specified inter-
face.
Dead Interval A number representing the OSPF Dead Interval for the specified inter-
face.
LSA Ack Interval A number representing the OSPF LSA Acknowledgement Interval
for the specified interface.
Transit Delay Interval A number representing the OSPF Transit Delay for the speci-
fied interface.
Authentication Type The OSPF Authentication Type for the specified interface are:
none, simple, and encrypt.
The information below will only be displayed if OSPF is enabled.
OSPF Interface Type Broadcast LANs, such as Ethernet and IEEE 802.5, take the
value
broadcast
. The OSPF Interface Type will be 'broadcast'.
State The OSPF Interface States are: down, loopback, waiting, point-to-
point, designated router, and backup designated router.
Designated Router The router ID representing the designated router.
Backup Designated Router The router ID representing the backup designated
router.
Number of Link Events The number of link events.
Metric Cost The cost of the OSPF interface.