Kontron AT890X Full-Size CLI - Manual (Page 262)

Management Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 6 - 20
6.6.11.1 no snmp-server enable traps bcaststorm
This command disables the broadcast storm trap. When enabled, broadcast storm traps
are sent only if the broadcast storm recovery mode setting associated with the port is
enabled.
Format no snmp-server enable traps bcaststorm
Mode Global Config
6.6.12 snmp-server enable traps linkmode
This command enables Link Up/Down traps for the entire switch. When enabled, link
traps are sent only if the Link Trap flag setting associated with the port is enabled.
“snmp trap link-status” on page 22.
Default enabled
Format snmp-server enable traps linkmode
Mode Global Config
6.6.12.1 no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
Format
no snmp-server enable traps linkmode
Mode Global Config
6.6.13 snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple
User Trap is sent when a user logs in to the terminal interface (EIA 232 or Telnet) and
there is an existing terminal interface session.
Default enabled
Format snmp-server enable traps multiusers
Mode Global Config
6.6.13.1 no snmp-server enable traps multiusers
This command disables Multiple User traps.
Format
no snmp-server enable traps multiusers
Mode Global Config
6.6.14 snmp-server enable traps stpmode
This command enables the sending of new root traps and topology change notification
traps.
Default enabled
Format snmp-server enable traps stpmode
Mode Global Config