Kontron AT890X Full-Size CLI - Manual (Page 247)

AT8901/2/3 Management Commands
Page 6 - 5 AT8901/2/3 CLI Reference Manual
Locally Administered MAC Address If desired, a locally administered MAC
address can be configured for in-band connectivity. To take effect,
'MAC Address Type' must be set to 'Locally Administered'. Enter the
address as twelve hexadecimal digits (6 bytes) with a colon between
each byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0, i.e. byte 0
should have the following mask 'xxxx xx10'. The MAC address used
by this bridge when it must be referred to in a unique fashion. It is rec-
ommended that this be the numerically smallest MAC address of all
ports that belong to this bridge. However it is only required to be
unique. When concatenated with dot1dStpPriority a unique
BridgeIdentifier is formed which is used in the Spanning Tree Proto-
col.
MAC Address Type Specifies which MAC address should be used for in-band con-
nectivity. The choices are the burned in or the Locally Administered
address. The factory default is to use the burned in MAC address.
Network Configuration Protocol Current Indicates which network protocol is
being used. The options are bootp | dhcp | none.
Java Mode Specifies if the switch should allow access to the Java applet in the
header frame. Enabled means the applet can be viewed. The factory
default is disabled.
Web Mode Specifies if the switch should allow access to the Web Interface.
6.1.10 show serviceport
This command displays service port configuration information.
Format
show serviceport
Mode Privileged EXEC
IP Address The IP address of the interface. The factory default value is 0.0.0.0
Subnet Mask The IP subnet mask for this interface. The factory default value is
0.0.0.0
Default Gateway The default gateway for this IP interface. The factory default value
is 0.0.0.0
ServPort Configuration Protocol Current Indicates what network protocol was
used on the last, or current power-up cycle, if any.
Burned in MAC Address The burned in MAC address used for in-band connectivity.
6.2 Console Port Access Commands
This section describes the commands you use to configure the console port. You can
use a serial cable to connect a management host directly to the console port of the
switch.
6.2.1 configuration
This command gives you access to the Global Config mode. From the Global Config
mode, you can configure a variety of system settings, including user accounts. From