Kontron AT890X Full-Size CLI - Manual (Page 268)

Management Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 6 - 26
If you use the token, the command configures the IP address to use for the
RADIUS accounting server. You can only configure one accounting server. If an
accounting server is currently configured, use the “no” form of the command to
remove it from the configuration. The IP address you specify must match that of a
previously configured accounting server. If you use the optional
parameter, the
command configures the UDP port to use when connecting to the RADIUS accounting
server. If a
is already configured for the accounting server, the new
replaces the previously configured . The must be a value in the range 1
- 65535, with 1813 being the default.
NOTE: To re-configure a RADIUS accounting server to use the default UDP
, set the parameter to 1813.
Format
radius server host {auth | acct} []
Mode Global Config
6.8.2.1 no radius server host
This command is used to remove the configured RADIUS authentication server or the
RADIUS accounting server. If the 'auth' token is used, the previously configured
RADIUS authentication server is removed from the configuration. Similarly, if the
'acct' token is used, the previously configured RADIUS accounting server is removed
from the configuration. The
parameter must match the IP address of the
previously configured RADIUS authentication / accounting server.
Format
no radius server host {auth | acct}
Mode Global Config
6.8.3 radius server key
This command is used to configure the shared secret between the RADIUS client and
the RADIUS accounting / authentication server. Depending on whether the 'auth' or
'acct' token is used, the shared secret is configured for the RADIUS authentication or
RADIUS accounting server. The IP address provided must match a previously
configured server. When this command is executed, the secret is prompted.
NOTE: The secret must be an alphanumeric value not exceeding 16 charac-
ters.
Format
radius server key {auth | acct}
Mode Global Config
6.8.4 radius server msgauth
This command enables the message authenticator attribute for a specified server.
Format
radius server msgauth
Mode Global Config
6.8.4.1 no radius server msgauth
This command disables the message authenticator attribute for a specified server.