Kontron AT890X Full-Size CLI - Manual (Page 119)

AT8901/2/3 Routing Commands
Page 3 - 7 AT8901/2/3 CLI Reference Manual
3.2.1 routing
This command enables IPv4 and IPv6 routing for an interface. You can view the
current value for this function with the
show ip brief
command. The value is labeled
as “Routing Mode.”
Default disabled
Format
routing
Mode Interface Config
3.2.1.1 no routing
This command disables routing for an interface.
You can view the current value for this function with the
show ip brief
command.
The value is labeled as “Routing Mode.”
Format no routing
Mode Interface Config
3.2.2 ip routing
This command enables the IP Router Admin Mode for the master switch.
Format
ip routing
Mode Global Config
3.2.2.1 no ip routing
This command disables the IP Router Admin Mode for the master switch.
Format
no ip routing
Mode Global Config
3.2.3 ip address
This command configures an IP address on an interface. You can also use this
command to configure one or more secondary IP addresses on the interface.The value
for
is the IP Address of the interface. The value for is a 4-
digit dotted-decimal number which represents the subnet mask of the interface. The
subnet mask must have contiguous ones and be no longer than 30 bits, for example
255.255.255.0. This command changes the label IP address in
show ip interface
.
Format.
ip address [secondary]
Mode Interface Config
3.2.3.1 no ip address
This command deletes an IP address from an interface. The value for is the
IP Address of the interface. The value for is a 4-digit dotted-decimal
number which represents the Subnet Mask of the interface.
Format
no ip address [secondary]