Kontron AT890X Full-Size CLI - Manual (Page 259)

AT8901/2/3 Management Commands
Page 6 - 17 AT8901/2/3 CLI Reference Manual
snmp-server bind network
no snmp-server bind serviceport
no snmp-server bind network
Mode Global Config
6.6.3 snmp-server community
This command adds (and names) a new SNMP community. A community is a
name associated with the switch and with a set of SNMP managers that manage it with
a specified privileged level. The length of
can be up to 16 case-sensitive
characters.
NOTE: Community names in the SNMP Community Table must be unique.
When making multiple entries using the same community name, the
first entry is kept and processed and all duplicate entries are ignored.
Default public and private, which you can rename
default values for the remaining four community names are blank
Format snmp-server community
Mode Global Config
6.6.3.1 no snmp-server community
This command removes this community name from the table. The is the
community name to be deleted.
Format
no snmp-server community
Mode Global Config
6.6.4 snmp-server community ipaddr
This command sets a client IP address for an SNMP community. The address is the
associated community SNMP packet sending address and is used along with the client
IP mask value to denote a range of IP addresses from which SNMP clients may use that
community to access the device. A value of 0.0.0.0 allows access from any IP address.
Otherwise, this value is ANDed with the mask to determine the range of allowed client
IP addresses. The name is the applicable community name.
Default 0.0.0.0
Format
snmp-server community ipaddr
Mode Global Config
6.6.4.1 no snmp-server community ipaddr
This command sets a client IP address for an SNMP community to 0.0.0.0. The name is
the applicable community name.
Format
no snmp-server community ipaddr
Mode Global Config