Kontron AT890X Full-Size CLI - Manual (Page 235)

AT8901/2/3 Utility Commands
Page 5 - 37 AT8901/2/3 CLI Reference Manual
• p-node—Peer-to-peer
• m-node—Mixed
• h-node—Hybrid (recommended)
Default none
Format netbios-node-type
Mode DHCP Pool Config
5.9.13.1 no netbios-node-type
This command removes the NetBIOS node Type.
Format
no netbios-node-type
Mode DHCP Pool Config
5.9.14 next-server
This command configures the next server in the boot process of a DHCP client.The
parameter is the IP address of the next server in the boot process, which is
typically a TFTP server.
Default inbound interface helper addresses
Format
next-server
Mode DHCP Pool Config
5.9.14.1 no next-server
This command removes the boot server list.
Format
no next-server
Mode DHCP Pool Config
5.9.15 option
The
option
command configures DHCP Server options. The <
code
> parameter
specifies the DHCP option code and ranges from 1-254. The
parameter specifies an NVT ASCII character string. ASCII character strings that
contain white space must be delimited by quotation marks. The
hex
parameter specifies hexadecimal data. In hexadecimal, character strings are two
hexadecimal digits. You can separate each byte by a period (for example, a3.4f.22.0c),
colon (for example, a3:4f:22:0c), or white space (for example, a3 4f 22 0c).
Default none
Format option {ascii string | hex
[...] | ip
[...]}
Mode DHCP Pool Config
5.9.15.1 no option
This command removes the DHCP Server options. The <
code
> parameter specifies the
DHCP option code.