Kontron AT890X Full-Size CLI - Manual (Page 149)

AT8901/2/3 Routing Commands
Page 3 - 37 AT8901/2/3 CLI Reference Manual
3.7.40.1 no trapflags
This command disables OSPF traps.
Format
no trapflags
Mode Router OSPF Config
3.7.41 show ip ospf
This command displays information relevant to the OSPF router.
Format show ip ospf
Mode Privileged EXEC
NOTE: Some of the information below displays only if you enable OSPF and
configure certain features.
Router ID A 32-bit integer in dotted decimal format identifying the router, about
which information is displayed. This is a configured value.
OSPF Admin Mode Shows whether the administrative mode of OSPF in the router
is enabled or disabled. This is a configured value.
ASBR Mode Reflects whether the ASBR mode is enabled or disabled. Enable
implies that the router is an autonomous system border router. Router
automatically becomes an ASBR when it is configured to redistribute
routes learnt from other protocol. The possible values for the ASBR
status is enabled (if the router is configured to re-distribute routes
learnt by other protocols) or disabled (if the router is not configured
for the same).
RFC 1583 Compatibility Reflects whether 1583 compatibility is enabled or disabled.
This is a configured value.
ABR Status Shows whether the router is an OSPF Area Border Router.
Exit Overflow Interval Shows the number of seconds that, after entering Overflow-
State, a router will attempt to leave OverflowState.
External LSA Count Shows the number of external (LS type 5) link-state advertise-
ments in the link-state database.
External LSA Checksum Shows the sum of the LS checksums of external link-state
advertisements contained in the link-state database.
New LSAs Originated Shows the number of new link-state advertisements that have
been originated.
LSAs Received Shows the number of link-state advertisements received determined
to be new instantiations.
External LSDB Limit Shows the maximum number of non-default AS-external-
LSAs entries that can be stored in the link-state database.
Default Metric Default value for redistributed routes.
Default Route Advertise Indicates whether the default routes received from other
source protocols are advertised or not
Always Shows whether default routes are always advertised.