Kontron AT890X Full-Size CLI - Manual (Page 257)

AT8901/2/3 Management Commands
Page 6 - 15 AT8901/2/3 CLI Reference Manual
6.5.4.1 no users snmpv3 authentication
This command sets the authentication protocol to be used for the specified user to
none. The
is the user name for which the specified authentication protocol
is used.
Format no users snmpv3 authentication
Mode Global Config
6.5.5 users snmpv3 encryption
This command specifies the encryption protocol used for the specified user. The valid
encryption protocols are
des or none.
If you select
des
, you can specify the required key on the command line. The
encryption key must be 8 to 64 characters long. If you select the
des
protocol but do
not provide a key, the user is prompted for the key. When you use the
des
protocol, the
login password is also used as the snmpv3 encryption password, so it must be a
minimum of eight characters. If you select
none , you do not need to provide a key.
The value is the login user name associated with the specified encryption.
You must enter the in the same case you used when you added the user.
To see the case of the , enter the
show users
command.
Default no encryption
Format
users snmpv3 encryption {none | des[key]}
Mode Global Config
6.5.5.1 no users snmpv3 encryption
This command sets the encryption protocol to none. The is the login user
name for which the specified encryption protocol will be used.
Format no users snmpv3 encryption
Mode Global Config
6.5.6 show loginsession
This command displays current Telnet and serial port connections to the switch.
Format
show loginsession
Mode Privileged EXEC
ID Login Session ID
User Name The name the user will use to login using the serial port or Telnet.
Connection From IP address of the Telnet client machine or EIA-232 for the serial
port connection.
Idle Time Time this session has been idle.
Session Time Total time this session has been connected.