Kontron AT890X Full-Size CLI - Manual (Page 222)

Utility Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 5 - 24
5.6.1 traceroute
Use the
traceroute
command to discover the routes that packets actually take when
traveling to their destination through the network on a hop-by-hop basis. The
value should be a valid IP address. The
[]
value should be a valid decimal
integer in the range of 0 (zero) to 65535. The optional port parameter is the UDP port
used as the destination of packets sent as part of the traceroute. This port should be an
unused port on the destination system. The default value is 33434.
Format
traceroute []
Mode Privileged EXEC
5.6.2 clear config
This command resets the configuration to the factory defaults without powering off the
switch. When you issue this command, a prompt appears to confirm that the reset
should proceed. When you enter
y
, you automatically reset the switch.
Format
clear config
Mode Privileged EXEC
5.6.3 clear counters
This command clears the statistics for a specified < unit/slot/port >, for all the ports, or
for the entire switch based upon the argument.
Format
clear counters {<unit/slot/port> | all}
Mode Privileged EXEC
5.6.4 clear igmpsnooping
This command clears the tables managed by the IGMP Snooping function and attempts
to delete these entries from the Multicast Forwarding Database.
Format clear igmpsnooping
Mode Privileged EXEC
5.6.5 clear pass
This command resets all user passwords to the factory defaults without powering off
the switch. You are prompted to confirm that the password reset should proceed.
Format
clear pass
Mode Privileged EXEC
5.6.6 clear port-channel
This command clears all port-channels (LAGs).
Format clear port-channel
Mode Privileged EXEC