Kontron AT890X Full-Size CLI - Manual (Page 176)

Quality of Service (QoS) Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 4 - 10
Format
match class-map
Mode Class-Map Config
NOTE:
• The parameters
<refclassname>
and
>
can not be the same.
• Only one other class may be referenced by a class.
• Any attempts to delete the > class while the class is still referenced
by any fails.
• The combined match criteria of > and > must be
an allowed combination based on the class type.
• Any subsequent changes to the
>
class match criteria must main-
tain this validity, or the change attempt fails.
• The total number of class rules formed by the complete reference class chain
(including both predecessor and successor classes) must not exceed a platform-
specific maximum. In some cases, each removal of a refclass rule reduces the max-
imum number of available rules in the class definition by one.
4.3.5.1 no match class-map
This command removes from the specified class definition the set of match conditions
defined for another class. The
is the name of an existing DiffServ
class whose match conditions are being referenced by the specified class definition.
Format
no match class-map
Mode Class-Map Config
4.3.6 match cos
This command adds to the specified class definition a match condition for the Class of
Service value (the only tag in a single tagged packet or the first or outer 802.1Q tag of
a double VLAN tagged packet). The value may be from 0 to 7.
NOTE: This command is not available on the Broadcom 5630x platform.
Default none
Format
match cos <0-7>
Mode Class-Map Config
4.3.7 match secondary-cos
This command adds to the specified class definition a match condition for the
secondary Class of Service value (the inner 802.1Q tag of a double VLAN tagged
packet). The value may be from 0 to 7.
NOTE: This command is not available on the Broadcom 5630x platform.
Default none
Format
match secondary-cos <0-7>
Mode Class-Map Config