Kontron AT890X Full-Size CLI - Manual (Page 158)

Routing Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 46
Hello Interval The configured hello interval for the OSPF virtual interface.
Dead Interval The configured dead interval for the OSPF virtual interface.
Iftransit Delay Interval The configured transit delay for the OSPF virtual interface.
Retransmit Interval The configured retransmit interval for the OSPF virtual inter-
face.
Authentication Type The configured authentication type of the OSPF virtual inter-
face.
State The OSPF Interface States are: down, loopback, waiting, point-to-
point, designated router, and backup designated router. This is the
state of the OSPF interface.
Neighbor State The neighbor state.
3.7.54 show ip ospf virtual-link brief
This command displays the OSPF Virtual Interface information for all areas in the
system.
Format
show ip ospf virtual-link brief
Modes Privileged EXEC
User EXEC
Area Id The area id of the requested OSPF area.
Neighbor The neighbor interface of the OSPF virtual interface.
Hello Interval The configured hello interval for the OSPF virtual interface.
Dead Interval The configured dead interval for the OSPF virtual interface.
Retransmit Interval The configured retransmit interval for the OSPF virtual inter-
face.
Transit Delay The configured transit delay for the OSPF virtual interface.
3.8 Routing Information Protocol (RIP) Commands
This section describes the commands you use to view and configure RIP, which is a
distance-vector routing protocol that you use to route traffic within a small network.
3.8.1 router rip
Use this command to enter Router RIP mode.
Format
router rip
Mode Global Config
3.8.2 enable (RIP)
This command resets the default administrative mode of RIP in the router (active).
Default enabled
Format
enable