Kontron AT890X Full-Size CLI - Manual (Page 215)

AT8901/2/3 Utility Commands
Page 5 - 17 AT8901/2/3 CLI Reference Manual
5.4.9 show sysinfo
This command displays switch information.
Format
show sysinfo
Mode Privileged EXEC
Switch Description Text used to identify this switch.
System Name Name used to identify the switch.The factory default is blank. To con-
figure the system name, see 6.6.1 “snmp-server” on page 6 - 16.
System Location Text used to identify the location of the switch. The factory default
is blank. To configure the system location, see 6.6.1 “snmp-server” on
page 6 - 16.
System Contact Text used to identify a contact person for this switch. The factory
default is blank. To configure the system location, see 6.6.1 “snmp-
server” on page 6 - 16.
System ObjectID The base object ID for the switch’s enterprise MIB.
System Up Time The time in days, hours and minutes since the last switch reboot.
MIBs Supported A list of MIBs supported by this agent.
5.4.10 show tech-support
Use the
show tech-support
command to display system and configuration
information when you contact technical support. The output of the
show tech-
support
command combines the output of the following commands:
• show version
• show sysinfo
• show port all
• show logging
• show event log
• show logging buffered
• show trap log
• show running config
Format show tech-support
Mode Privileged EXEC
5.4.11 show boardinfo post-status
This command displays the system power on self test status.
Format
show boardinfo post-status system
Mode Privileged EXEC
5.4.12 show boardinfo sensors
This command displays the current sensor readings. It can either display a compressed
list of all sensors or display full readings for a specified sensor. The (of
SDR) for a specific sensor is displayed in the compressed list
Format
show boardinfo sensors { | brief}