Kontron AT890X Full-Size CLI - Manual (Page 230)

Utility Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 5 - 32
Poll Timeout Poll timeout value in seconds for SNTP clients.
Poll Retry
Poll retry value for SNTP clients.
5.8.11 show sntp server
This command is used to display SNTP server settings and configured servers.
Format
show sntp server
Mode Privileged EXEC
Server IP Address IP Address of configured SNTP Server
Server Type Address Type of Server.
Server Stratum Claimed stratum of the server for the last received valid packet.
Server Reference ID Reference clock identifier of the server for the last received
valid packet.
Server Mode SNTP Server mode.
Server Maximum Entries Total number of SNTP Servers allowed.
Server Current Entries Total number of SNTP configured.
For each configured server:
IP Address IP Address of configured SNTP Server.
Address Type Address Type of configured SNTP server.
Priority
IP priority type of the configured server.
Version SNTP Version number of the server. The protocol version used to
query the server in unicast mode.
Port Server Port Number
Last Attempt Time Last server attempt time for the specified server.
Last Update Status Last server attempt status for the server.
Total Unicast Requests Number of requests to the server.
Failed Unicast Requests Number of failed requests from server.
5.9 DHCP Server Commands
This section describes the commands you to configure the DHCP server settings for the
switch. DHCP uses UDP as its transport protocol and supports a number of features
that facilitate in administration address allocations.
5.9.1 ip dhcp pool
This command configures a DHCP address pool name on a DHCP server and enters
DHCP pool configuration mode.
Default none
Format
ip dhcp pool
Mode Global Config