Kontron AT890X Full-Size CLI - Manual (Page 234)

Utility Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 5 - 36
Format
bootfile
Mode DHCP Pool Config
5.9.10.1 no bootfile
This command deletes the boot image name.
Format no bootfile
Mode DHCP Pool Config
5.9.11 domain-name
This command specifies the domain name for a DHCP client. The specifies
the domain name string of the client.
Default none
Format
domain-name
Mode DHCP Pool Config
5.9.11.1 no domain-name
This command removes the domain name.
Format no domain-name
Mode DHCP Pool Config
5.9.12 netbios-name-server
This command configures NetBIOS Windows Internet Naming Service (WINS) name
servers that are available to DHCP clients.
One IP address is required, although one can specify up to eight addresses in one
command line. Servers are listed in order of preference (address1 is the most preferred
server, address2 is the next most preferred server, and so on).
Default none
Format
netbios-name-server
Mode DHCP Pool Config
5.9.12.1 no netbios-name-server
This command removes the NetBIOS name server list.
Format
no netbios-name-server
Mode DHCP Pool Config
5.9.13 netbios-node-type
The command configures the NetBIOS node type for Microsoft Dynamic Host
Configuration Protocol (DHCP) clients.type Specifies the NetBIOS node type. Valid
types are:
• b-node—Broadcast