Kontron AT890X Full-Size CLI - Manual (Page 232)

Utility Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 5 - 34
Format
default-router [....]
Mode DHCP Pool Config
5.9.4.1 no default-router
This command removes the default router list.
Format no default-router
Mode DHCP Pool Config
5.9.5 dns-server
This command specifies the IP servers available to a DHCP client. Address parameters
are valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP
address 0.0.0.0 is invalid.
Default none
Format
dns-server [....]
Mode DHCP Pool Config
5.9.5.1 no dns-server
This command removes the DNS Server list.
Format no dns-server
Mode DHCP Pool Config
5.9.6 hardware-address
This command specifies the hardware address of a DHCP client. Hardware-address is
the MAC address of the hardware platform of the client consisting of 6 bytes in dotted
hexadecimal format. Type indicates the protocol of the hardware platform. It is 1 for 10
MB Ethernet and 6 for IEEE 802.
Default ethernet
Format hardware-address
Mode DHCP Pool Config
5.9.6.1 no hardware-address
This command removes the hardware address of the DHCP client.
Format
no hardware-address
Mode DHCP Pool Config
5.9.7 host
This command specifies the IP address and network mask for a manual binding to a
DHCP client. Address and Mask are valid IP addresses; each made up of four decimal
bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid. The prefix-length is an
integer from 0 to 32
Default none