5 snmp-server community ipmask, 6 snmp-server community mode, 7 snmp-server community ro – Kontron AT890X Full-Size CLI User Manual
Page 260: Snmp-server community ipmask - 18, Snmp-server community mode - 18, Snmp-server community ro - 18

Management Commands
AT8901/2/3
AT8901/2/3 CLI Reference Manual
Page 6 - 18
6.6.5
snmp-server community ipmask
This command sets a client IP mask for an SNMP community. The address is the
associated community SNMP packet sending address and is used along with the client
IP address value to denote a range of IP addresses from which SNMP clients may use
that community to access the device. A value of 255.255.255.255 will allow access
from only one station, and will use that machine's IP address for the client IP Address.
A value of 0.0.0.0 will allow access from any IP address. The name is the applicable
community name.
Default
0.0.0.0
Format
snmp-server community ipmask
Mode
Global Config
6.6.5.1
no snmp-server community ipmask
This command sets a client IP mask for an SNMP community to 0.0.0.0. The name is
the applicable community name. The community name may be up to 16 alphanumeric
characters.
Format
no snmp-server community ipmask
Mode
Global Config
6.6.6
snmp-server community mode
This command activates an SNMP community. If a community is enabled, an SNMP
manager associated with this community manages the switch according to its access
right. If the community is disabled, no SNMP requests using this community are
accepted. In this case the SNMP manager associated with this community cannot
manage the switch until the Status is changed back to Enable.
Default
private and public communities - enabled
other four - disabled
Format
snmp-server community mode
Mode
Global Config
6.6.6.1
no snmp-server community mode
This command deactivates an SNMP community. If the community is disabled, no
SNMP requests using this community are accepted. In this case the SNMP manager
associated with this community cannot manage the switch until the Status is changed
back to Enable.
Format
no snmp-server community mode
Mode
Global Config
6.6.7
snmp-server community ro
This command restricts access to switch information. The access mode is read-only
(also called public).
Format
snmp-server community ro