Kontron AT890X Full-Size CLI - Manual (Page 148)

Routing Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 36
Default metric—unspecified
type—2
tag—0
Format redistribute {rip | bgp | static | connected} [metric <0-
16777214>] [metric-type {1 | 2}] [tag <0-4294967295>]
[subnets]
Mode Router OSPF Config
3.7.37.1 no redistribute
This command configures OSPF protocol to prohibit redistribution of routes from the
specified source protocol/routers.
Format
no redistribute {rip | bgp | static | connected} [metric]
[metric-type] [tag] [subnets]
Mode Router OSPF Config
3.7.38 maximum-paths (OSPF)
This command sets the number of paths that OSPF can report for a given destination
where
maxpaths
is platform dependent.
Default 4
Format
maximum-paths
Mode Router OSPF Config
3.7.38.1 no maximum-paths
This command resets the number of paths that OSPF can report for a given destination
back to its default value.
Format
no maximum-paths
Mode Router OSPF Config
3.7.39 timers spf
Use this command to configure the SPF delay time and hold time. The valid range for
both parameters is 0-65535 seconds.
Default delay-time—5
hold-time—10
Format
timers spf
Mode Router OSPF Config
3.7.40 trapflags (OSPF)
This command enables OSPF traps.
Default enabled
Format trapflags
Mode Router OSPF Config