Kontron AT890X Full-Size CLI - Manual (Page 233)

AT8901/2/3 Utility Commands
Page 5 - 35 AT8901/2/3 CLI Reference Manual
Format
host
Mode DHCP Pool Config
5.9.7.1 no host
This command removes the IP address of the DHCP client.
Format no host
Mode DHCP Pool Config
5.9.8 lease
This command configures the duration of the lease for an IP address that is assigned
from a DHCP server to a DHCP client. The overall lease time should be between 1-
86400 minutes. If you specify
infinite , the lease is set for 60 days. You can also
specify a lease duration. Days is an integer from 0 to 59. Hours is an integer from 0 to
1439.
Minutes
is an integer from 0 to 86399.
Default 1 (day)
Format lease [{ [] [] | infinite}]
Mode DHCP Pool Config
5.9.8.1 no lease
This command restores the default value of the lease time for DHCP Server.
Format
no lease
Mode DHCP Pool Config
5.9.9 network (DHCP Pool Config)
Use this command to configure the subnet number and mask for a DHCP address pool
on the server. Network-number is a valid IP address, made up of four decimal bytes
ranging from 0 to 255. IP address 0.0.0.0 is invalid. Mask is the IP subnet mask for the
specified address pool. The prefix-length is an integer from 0 to 32.
Default none
Format
network [{ | }]
Mode DHCP Pool Config
5.9.9.1 no network
This command removes the subnet number and mask.
Format
no network
Mode DHCP Pool Config
5.9.10 bootfile
The command specifies the name of the default boot image for a DHCP client. The
specifies the boot image file.
Default none