Kontron AT890X Full-Size CLI - Manual (Page 221)

AT8901/2/3 Utility Commands
Page 5 - 23 AT8901/2/3 CLI Reference Manual
5.5.10 show logging hosts
This command displays all configured logging hosts.
Format
show logging hosts
Mode Privileged EXEC
Host Index (Used for deleting hosts)
IP Address IP address of the logging host.
Severity Level The minimum severity to log to the specified address. The possible
values are emergency (0), alert (1), critical (2), error (3), warning (4),
notice (5), info (6), or debug (7).
Port Displays the server port number, which is the port on the local host
from which syslog messages are sent.
Host Status The state of logging to configured syslog hosts. If the status is disable,
no logging occurs.
5.5.11 show logging traplogs
This command displays SNMP trap events and statistics.
Format
show logging traplogs
Mode Privileged EXEC
Number of Traps Since Last Reset Shows the number of traps since the last boot.
Trap Log Capacity Shows the number of traps the system can retain.
Number of Traps Since Log Last Viewed Shows the number of new traps since the
command was last executed.
Log Shows the log number.
System Time Up Shows how long the system had been running at the time the trap
was sent.
Trap Shows the text of the trap message.
5.5.12 show logging backtrace
This command displays the backtrace file last created. A backtrace file is created when
the application stops unexpectedly.
Format
show logging backtrace
Mode Privileged EXEC
5.6 System Utility and Clear Commands
This section describes the commands you use to help troubleshoot connectivity issues
and to restore various configurations to their factory defaults.