Kontron AT890X Full-Size CLI - Manual (Page 143)

AT8901/2/3 Routing Commands
Page 3 - 31 AT8901/2/3 CLI Reference Manual
3.7.22.1 no default-metric (OSPF)
This command is used to set a default for the metric of distributed routes.
Format
no default-metric
Mode Router OSPF Config
3.7.23 distance ospf (OSPF)
This command sets the route preference value of OSPF in the router. Lower route
preference values are preferred when determining the best route. The type of OSPF can
be intra, inter, type-1, or type-2. The OSPF specification (RFC 2328) requires that
preferences must be given to the routes learned via OSPF in the following order: intra
< inter < type-1 < type-2. The <
preference > range is 1 to 255. A route with a
preference of 255 cannot be used to forward traffic.
Default intra—8
inter—10
type-1—13
type-2—50.
Format
distance ospf {intra | inter | type1 | type2}
Mode Router OSPF Config
3.7.23.1 no distance ospf
This command sets the default route preference value of OSPF in the router. The type
of OSPF can be intra, inter, type-1, or type-2.
Format no distance ospf {intra | inter | type1 | type2}
Mode Router OSPF Config
3.7.24 distribute-list out (OSPF)
Use this command to specify the access list to filter routes received from the source
protocol.
Format
distribute-list <1-199> out {rip | bgp | static | con-
nected}
Mode Router OSPF Config
3.7.24.1 no distribute-list out
Use this command to specify the access list to filter routes received from the source
protocol.
Format
no distribute-list <1-199> out {rip | bgp | static | con-
nected}
Mode Router OSPF Config
3.7.25 exit-overflow-interval (OSPF)
This command configures the exit overflow interval for OSPF. It describes the number
of seconds after entering Overflow state that a router will wait before attempting to