Kontron AT890X Full-Size CLI - Manual (Page 203)

AT8901/2/3 Utility Commands
Page 5 - 5 AT8901/2/3 CLI Reference Manual
5.3.2 set board ipmi-controller debug
This command enables temporary IPMI controller serial debug output on the
management serial console. .
Format
set board ipmi-controller debug {on | off}
Mode Privileged EXEC
NOTE: Use this command with care as it may render the console useless until a full
board reset is executed
5.3.3 set board fcap
This command enables or disables some firmware capabilities. If the handle capability
is enabled, the hardware handle is ignored.
Format
set board fcap handle enable
set board fcap handle disable
Mode Privileged EXEC
5.3.4 set board routing
This commands sets which interface should be configured with layer 3 functionality.
This becomes effective after the next reboot. You should use for this reboot the factory
defaults for the configuration to avoid inconsistency (layer 3 commands may be
implemented in the current configuration for the fabric interface which reboots without
layer 3 functionality).
Format
set board routing base
set board routing extension
set board routing none
Mode Privileged EXEC
NOTE: The “ set board routing extension” command is only available on a
AT8902
5.3.5 atca port override
This command overrides the current ekeying status. The user specified port status
(enable/disable) is set if not set already by e-keying. The status is marked as user
specified. Supported interfaces can be seen in Table 7.1. “Interface mapping” on page
5 - 5
Format
atca port override {enable | disable}
Mode Global Config
Table 7.1. Interface mapping
I/F Description Channel Port
base base interface ethernet 1-16 0
update AT8901/2/3 update channel ethernet 1 0
shmc PICMG 3.0 Shelf manager cross connect 1-20 0
extension extension fabric interface ethernet 1-15 0-1