B&G H2000 Pilot *DISCONTINUED* - Manual (Page 210)

h2000 User Manual
210 HB-0845-06
Collective Addresses
FA
H
All 20/20s
FB
H
All Halcyon FFDs
FC
H
All Pilot FFDs
FD
H
All Processor Nodes
FE
H
All FFDs
FF
H
Entire System
Notes
• When the system is reset, all calibration, damping and
alarm values will be set back to default settings, all log
values and trip functions will be reset to zero. All display
units will reset to their default page settings. After a
delay of about 20 seconds the system should be switched
OFF and then back ON twice to complete the reset
procedure.
• If the Depth board is reset, the FILTER PC setting for
boat speed calibration will need to be reset to 10% as
follows:
SPEED
→
BOAT SPD, CALBRATE
→ → → →
CORRCTN
→ → → →
FILTER PC
6.1.3 Versions
This option allows the user to obtain the software version
numbers for the FFD (DISPLAY), Depth Board (DEPTH),
Wind Board (WIND), Expansion Unit (EXP UNIT) and
Pilot, if fitted. With 'VERSIONS' flashing on the display,
press Enter. Then use the Scroll Up Key to select the
device whose version number is required and press Enter to
display the software checksum of that device, in the bottom
display. The last two digits of the checksum are the software
version number.