B&G Network Compass User Manual
B&G Accessories for electrical
NETWORK COMPASS USER MANUAL
CONTENTS
GENERAL INTRODUCTION TO B&G NETWORK.........................................................2
INTRODUCTION TO NETWORK COMPASS.................................................................3
EXAMPLE SYSTEMS USING NETWORK COMPASS...................................................4
ENABLING/DISABLING THE TIMER BEEPS ..............................................................13
SETTING THE DISPLAY FOR TRUE OR MAGNETIC READINGS .............................16
1
Table of contents
Document Outline
- GENERAL INTRODUCTION TO B&G NETWORK
- INTRODUCTION TO NETWORK COMPASS
- COMPASS DISPLAY UNIT
- EXAMPLE SYSTEMS USING NETWORK COMPASS
- INITIAL POWER-UP
- SETTING THE DISPLAY BACK LIGHTING
- THE OFF COURSE DISPLAY
- SETTING THE COURSE MEMORIES
- THE XTE DISPLAY
- THE RUDDER DISPLAY
- THE HEAD/LIFT DISPLAY
- USING THE TIMER
- SETTING THE TIMER
- ENABLING/DISABLING THE TIMER BEEPS
- ENABLING THE OFF COURSE ALARM
- SETTING THE COMPASS DAMPING
- SETTING THE COMPASS OFFSET
- SETTING THE VARIATION
- SETTING THE DISPLAY FOR TRUE OR MAGNETIC READINGS
- ENABLING THE HEAD/LIFT MODE
- SELECTING THE DISPLAY MODE
- CALIBRATING THE COMPASSRemember that a compass offset may be entered if the heading shows a fixed error (see section SETTING THE COMPASS OFFSET). The purpose of a calibration swing as described in this section is to measure the deviation pattern of the
- TROUBLESHOOTING
- INSTALLATION
- SITING THE FLUXGATE
- INSTALLATION DATA
- SPECIFICATIONS