B&G H2000 Pilot *DISCONTINUED* - Manual (Page 113)

HB-0845-06 113
Add for Waterline
Subtract for Keel
Transducer
Figure 14 - Depth Datum
The datum is entered under:
DEPTH
→
DEPTH, CALBRATE
→ → → →
DATUM
3.8 AFT DEPTH
The h2000 has the facility to display NMEA depth data
from an auxiliary depth source. Any NMEA depth
information input into the NMEA port on the h2000 Main
Processor is displayed on the system as Aft Depth.
A depth datum offset is available for the AFT DEPTH
function. The datum is entered under:
DEPTH
→
AFT DPTH, CALBRATE
→ → → →
CAL VAL 1
Additionally, it is possible to re-name the function AFT
DEPTH by selecting one of the pre-defined function names.
This is done by entering the corresponding number under:
DEPTH
→
AFT DPTH, CALBRATE
→ → → →
CAL VAL 2