B&G H2000 Pilot *DISCONTINUED* - Manual (Page 147)

HB-0845-06 147
Note
• Functions marked with an * are NMEA Functions and
are available only when a suitable Position Fixer is
interfaced with the system.
5.5.3 Function Selection - Remote Pushbutton
If a Remote Button is connected to a 20/20 Display any one
of the 14 pre-set functions may be selected by pressing and
holding down the associated Button. The Display will then
cycle through the functions. When the required function is
displayed, release the Button.
If the Button is held down too long and the required
function is missed, press and hold down the Button again.
The Display will then cycle though the functions in reverse
order. When the required function is displayed, release the
Button.
5.5.4 Function Selection - FFD
An alternative to using a dedicated Remote Pushbutton, is to
control the 20/20 using any one of the standard FFDs on the
system. Any 20/20 can be controlled from any FFD.
To change the function displayed on a 20/20 using a
standard FFD, proceed as follows:
1. At the FFD, press and hold down the Page Key
for approximately 3 seconds. The FFD display
will change to show the function displayed on the
20/20 together with the display number. The
selected 20/20 display will start to flash.
2. (2) Using the Scroll Down Key cycle through
the 20/20 numbers and select the required Display
Number, the selected 20/20 will flash.
3. Using the Scroll Up Key cycle through the 14
pre-set functions until the required function is
displayed on the FFD. Release the Scroll Up Key.