B&G H2000 Pilot *DISCONTINUED* - Manual (Page 112)

h2000 User Manual
112 HB-0845-06
3.6.3 Heel and Trim angle from Halcyon Gyro
Compass
The heel and trim information from the Halcyon Gyro
Stabilised Compass is displayed in the PERFORM menu.
The H symbol will be placed on left indicating heel to port
and on the right for heel to starboard. The display will
always be shown to 1 decimal point
The U symbol on the left indicates that the bow is up, while
a d will be shown indicating bow down. The display will
always be shown to 1 decimal point
Both heel and trim have an offset calibration to allow for
any constant errors, adding or subtracting from CAL VAL 1
will correct this.
PERFORM
→
HEEL, CALIBRATE
→ → → →
CAL VAL 1
If you have heel and trim sensors connected to your system
as well as a Halcyon Gyro Stabilised Compass then the Heel
and Trim from the Compass will be used by default. If you
wish to use your external sensors then set CAL VAL 2 to
‘0’.
PERFORM
→
HEEL, CALIBRATE
→ → → →
CAL VAL 2
3.7 DEPTH
A typical transducer installation is through the hull at a
suitable position between the water line and the bottom of
the keel. A DATUM (offset value) can be set, such that the
depth display refers to either the water line or the keel line.