B&G H2000 Pilot *DISCONTINUED* - Manual (Page 105)

HB-0845-06 105
Notes
• Hydra Pilots, Hercules Pilots, HS Pilots and Halcyon
FFDs will also require the Heading Node to be set to
your desired choice. Refer to the relevant user manual
for further information.
• 20/20 displays will require Heading to be re-selected
following Heading node selection. Simply re-select this
function. Refer to Para 5.4.5 for more information.
3.5.3 Halcyon 2000 Compass Calibration Procedure
1. Check for any magnetic devices placed near the
compass, especially ones that are out of their
normal places.
2. On a calm day select a stretch of open water with
little traffic (so you will not have to take avoiding
action which would affect the calibration). The
flatter the water and the less the wind the easier it
will be to meet the conditions for calibration.
3. Check for and avoid sailing close to any large
steel structures nearby, that may cause additional,
erratic deviations.
4. Scroll to the NAVIGATE menu and select COMP
CAL on the top half of the display. The display
shows OFF.
5. Press Scroll Down until the lower text shows
CALBRATE flashing.
6. Press the Enter key twice to display START and
a default setting of ‘0’.
7. Press the Enter key once and the ‘0’ starts to
flash. Use the Scroll Up key to change the value
to ‘1’.
8. Press the Enter key. The display now shows
000
°
.
9. At a speed not exceeding five knots, turn the boat
through 360
°
at a rate not greater than 2-3
°
per