B&G H2000 Pilot *DISCONTINUED* - Manual (Page 108)

h2000 User Manual
108 HB-0845-06
Enter the value to offset your heading e.g. if your heading
displays 100
°
and it should read 97
°
, then the value to enter
would be –3.
3.5.5 Halcyon Gyro Processor Setup
Data under the MISC > HALCYON function describes the
current mode of the Halcyon Gyro Processor, and are as
follows:
OFF
No heading detected from either a Halcyon Gyro
Stabilised Compass sensor or a B&G system
compass
GYRO
Receiving data from Halcyon Gyro Stabilised
Compass or NMEA input to Halcyon Gyro
Processor
SYS
Receiving data from a B&G system compass or
NMEA input to NMEA FFD or performance
processor
PASS
Calibration swing is complete
FAIL
Calibration swing failed and the compass needs
to be re-calibrated
xxxº Number of degrees turned during calibration
swing, indicates calibration swing in progress
3.5.6 Halcyon Gyro Processor NMEA output setup
NMEA sentence output settings determine what sentences
are output with respect to which heading source is available.
MISC
→
HALCYON, CALBRATE
→ → → →
CAL VAL 2 (NMEA MDE)