B&G H2000 Pilot *DISCONTINUED* - Manual (Page 186)

h2000 User Manual
186 HB-0845-06
TYPE NO. RATING
Masthead
rig 0 26.20 IOR rated feet
Fractional rig 1 22.50 IOR rated feet
ULDB 2 29.50 IOR rated feet
5.15.19 Input Polar Table Wind Speed
####
PW,s,xx.x(CR)
This command permits values in the wind speed column of
the currently selected Polar Table to be altered.
s = single digit value 0 to 9 representing a row in the Polar
Table (see Table 10)
xx.x = wind speed in knots of 00.0 to 99.9
Notes
• It is important that the wind speeds in the polar table lie
in ascending order, i.e. s = 0 corresponds to the smallest
wind speed value, s = 9 corresponds to the largest wind
speed value. If, by using the
####
PW command, the wind
speed values become disordered then 'Err 5' will be
displayed on Reaching and Tacking performance.
• Duplicate non-zero values for wind speed must not exist
in the wind speed column of the polar table. If duplicate
values are introduced using the PW command then 'Err 6'
will be displayed on Reaching and Tacking performance.
• If less than ten Wind Speeds are required, the first values
must be set to zero.
5.15.20 Output Apparent Wind Correction Table
Values
The h2000 contains two tables that can be used to correct
the measured apparent wind values which are to be used in
further calculations. These do not affect the values of
apparent wind speed or apparent wind angle displayed.
Table 11 is an example of the apparent wind speed
correction table and Table 12 is an example of the apparent
wind angle table.