Rockwell Automation Motion Analyzer Software - Manual (Page 67)

Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012 67
Welcome to Motion Analyzer Software Chapter 1
1.2.4.1.1.1. Axis Mapping
Information about .L5X file that Motion Analyzer generates is displayed at the
top of the screen as read only information.
Table 42 - Axis Mapping Properties
The name you define for each axis in Motion Analyzer software is used to create a
RSLogix 5000 axis tag. Underscore characters replace spaces in the name defined
in Motion Analyzer software. To change these names you must exit the Export to
RSLogix 5000 wizard and change the names by right-clicking each axis in the
Motion Analyzer explorer tree.
All axes in your Motion Analyzer (.mba) file appear in the table. If they will
export without trouble, a green status check is displayed.
Attribute Description
Controller Name
Motion Analyzer software assigns a default name for the controller. You can edit this once
the file has been loaded.
Controller Type
Motion Analyzer software creates a file with a default controller type. You can edit this
once the file has been loaded.
Chassis Type
Motion Analyzer software creates a file with a default Logix chassis. You may change your
chassis type once the file has been loaded.