Rockwell Automation Motion Analyzer Software - Manual (Page 272)

272 Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012
Chapter 4 Just Quote
4.2. IPIM Power Supply/
Accessories View
Power Supply Accessories view of an IPIM module helps you select options for
hybrid and network lengths, hybrid coupler cables, and bulkhead adapters.
Figure 219 - IPIM Module Selection
Table 167 - Configure IPIM Module BOM Tab Descriptions
Figure 220 - Configure IPIM Module BOM Tab
Options Description
Step 1 ( Figure 219 ) IPIM module IPIM module selected on the IPIM Module tab is displayed here.
Step 2 ( Figure 219 ) Hybrid cables Hybrid cable lengths selected on the Cable Lengths tab are displayed here.
Step 3 ( Figure 219 ) Network cables
Network cables can be routed with the hybrid cables, so network cable lengths
should be the same as the hybrid cable. The IPIM-to-IDM1 cable must have a
straight connector to the IPIM module.
Step 4 ( Figure 219 ) Hybrid coupler The hybrid coupler connects between two hybrid cables, to bypass an IDM unit.
Step 5 ( Figure 220 )
Network
bulkhead adapter Use the network bulkhead adapter for securing network cables as they pass
through the cabinet.