Digital outputs, Frequency i/o, 2 digital outputs – Rockwell Automation WebPak 3000 DC Drive Application Workbook Version 1.1 User Manual
Page 76: 3 frequency i/o
13-2
WebPak 3000 DC Drive Application Workbook, Version 1.1
Refer to figure A.21 in Appendix A of the software manual (D2-3444) for a block
diagram of the analog outputs. The following parameters are used to configure the
analog outputs:
13.2 Digital Outputs
The I/O Expansion board provides two user-selectable digital outputs. If you use these
outputs, you need to set parameters that select the source that drives the output and
whether the output is normally open or normally closed.
Refer to figure A.24 in Appendix A of the software manual for a block diagram of the
digital outputs. The following parameters are used to configure the digital outputs:
13.3 Frequency I/O
The I/O Expansion board provides one unipolar frequency output. The output is
unfiltered. The full scale value (FSV) is based on the selected parameter group: load,
speed, voltage, power, field, or other.
The frequency output is read every 10 ms.
•
ANLG
OUT
1
GAIN
ADJ
(P.400)
P.400 =
•
ANLG
OUT
1
ZERO
ADJ
(P.402)
P.402 =
•
ANLG
OUT
1
FILTER
EN
(P.406)
P.406 =
•
ANLG
OUT
2
GAIN
ADJ
(P.401)
P.401 =
•
ANLG
OUT
2
ZERO
ADJ
(P.403)
P.403 =
•
ANLG
OUT
2
SELECT
(P.405)
P.405 =
•
ANLG
OUT
2
FILTER
EN
(P.407)
P.407 =
•
ANLG
OUT
3
SELECT
(P.418)
P.418 =
•
ANLG
OUT
3
SIG
TYPE
(P.419)
P.419 =
•
ANLG
OUT
3
GAIN
ADJ
(P.420)
P.420 =
•
ANLG
OUT
4
SELECT
(P.421)
P.421 =
•
ANLG
OUT
4
GAIN
ADJ
(P.422)
P.422 =
•
DIG
OUT
1
CONTACT
TYP
(P.410)
P.410 =
•
DIG
OUT
1
SELECT
(P.409)
P.409 =
•
DIG
OUT
2
CONTACT
TYP
(P.412)
P.412 =
•
DIG
OUT
2
SELECT
(P.411)
P.411 =