Rockwell Automation WebPak 3000 DC Drive Application Workbook Version 1.1 - Manual (Page 37)

Configuring the Field Current Regulator 5-3
▲ Set FIELD SHAPING TYPE (P.539). The choices are:
SPEED - The index values are tabled to follow the absolute value of
motor rotational speed by multiplying the absolute value of SPD
SOURCE SELECT OUT (P.193) with NORM ROLL DIAMETER (P.131). The
product is limited to a high value of GEAR IN SPEED (P.011) and a low
value of MOTOR SPD AT MAX FLD (P.540), which typically is the motor
speed with the motor field excitation set at MOTOR HOT FLD AMPS
(P.510). That is, full field and with the armature voltage set at MOTOR
RATED ARM VOLTS (P.009).
DIAMETER - The index values are tabled to follow the output of the
diameter calculator, ROLL DIAMETER (P.865) and limited by FULL FIELD
DIAMETER (P.124) and WEAKENED FIELD DIA (P.126).
þ If FIELD SHAPING TYPE (P.439) = SPEED :
▲ Set MOTOR SPD AT MAX FLD (P.540).
▲ Set FULL FIELD DIAMETER (P.124).
▲ Set WEAKENED FIELD DIA (P.126) .
▲ Set FIELD INPUT 1 (P.530).
▲ Set FIELD INPUT 2 (P.531).
▲ Set FIELD INPUT 3 (P.532).
▲ Set FIELD INPUT 4 (P.533).
▲ Set FIELD INPUT 5 (P.534).
▲ Set FIELD INPUT 6 (P.535).
▲ Set FIELD INPUT 7 (P.536).
Range: SPEED , DIAMETER P.539 =
Range: 10 RPM to P.017 P.540 = RPM
Range: P.126 to P.125 P.124 = INCHES
Range: P.830 to P.124 P.126 = INCHES
Range: 0 to 5000 RPM P.530 = RPM
Range: 0 to 5000 RPM P.531 = RPM
Range: 0 to 5000 RPM P.532 = RPM
Range: 0 to 5000 RPM P.533 = RPM
Range: 0 to 5000 RPM P.534 = RPM
Range: 0 to 5000 RPM P.535 = RPM
Range: 0 to 5000 RPM P.536 = RPM