How licenses are distributed between license pools, E 83) – Rockwell Automation FactoryTalk Historian SE 4.0 Installation and Configuration Guide User Manual
Page 83

Configuring FactoryTalk Historian Chapter 5
Rockwell Automation Publication HSE-IN025A-EN-E–September 2013
83
When you allocate licenses to interface types (or point sources), you
take the licenses from either of the license pools.
To use the licenses:
1. Learn how FactoryTalk Historian distributes individual
licenses between the license pools. (page 83)
2. Assign the license activations to your Historian server (page
3. Allocate the individual licenses to interface types (or point
sources) (page 90).
When you acquire license activations for your FactoryTalk
Historian and assign them to your Historian server, the system
automatically distributes individual licenses from the license
activations between the General and Rockwell license pools.
The system takes into account the following license activations to
calculate the volume of the individual license pools:
• FHSE3ADD
• FHSE
• FHLD
• PTY3
If you want to calculate how licenses from your license activations
will be distributed between the license pools, follow the steps
described below.
TIP
The symbols used in the formulas presented below, mean the following:
∑
"the sum of"
Min "the lower value of the two in the brackets"
Max "the greater value of the two in the brackets"
How Licenses Are Distributed
Between License Pools