Rockwell Automation FactoryTalk Historian SE 4.0 Installation and Configuration Guide - Manual (Page 75)

Configuring FactoryTalk Historian Chapter 5
Rockwell Automation Publication HSE-IN025A-EN-E–September 2013 75
5. Click a security component to check its privileges in the
Permissions for… list.
You can modify the privileges of the component for the
database table to the extent that is allowed by the component’s
configuration. See "Historian Security Components and Their
Privileges (page 65)" for more information.
6. Click OK.
If you use Microsoft Windows Firewall on the computers on which
you have installed FactoryTalk Historian SE, the firewall
configuration is performed automatically during the installation of
individual FactoryTalk Historian components, using the Rockwell
Firewall Configuration Utility (WFCU).
If you use another utility, you need to configure the firewall
manually following the steps presented below. Refer to the user
Configuring Firewall for
FactoryTalk Historian