Rockwell Automation 294D ArmorStart LT Distributed Motor Controller DeviceNet Version - User Manual - Manual (Page 127)

Rockwell Automation Publication 290D-UM001A-EN-P - June 2012 127
Bulletin 290D/291D/294D Programmable Parameters Chapter 4
SensorSourceV (IPS)
[UnswitchedVolts]
This parameter determines the incoming
unswitched control voltage across
terminals A2…A3.
(IPS) available voltage on input Sensor
Source Pin 1 for all I/O points.
Parameter Number 12
Access Rule GET
Data Type UINT
Group Basic Status
Units x.xx Volts
Minimum Value 0
Maximum Value 65535
Default Value 0
InternalFanRPM
This parameter determines the
Revolutions Per Minute (RPM) of the
internal cooling fan.
Parameter Number 13
Access Rule GET
Data Type UINT
Group Basic Status
Units RPM
Minimum Value 0
Maximum Value 65535
Default Value 0
ElapsedRunTime
This parameter determines the
accumulated run time displayed in 10 hour
increments.
1 = 10 Hrs
Parameter Number 14
Access Rule GET
Data Type UINT
Group Basic Status
Units —
Minimum Value 0
Maximum Value 9999
Default Value 0
DriveTemperature
This parameter determines the
present operating temperature
of the power section.
Parameter Number 15
Access Rule GET
Data Type UINT
Group Basic Status
Units °C
Minimum Value 0
Maximum Value 9999
Default Value 0