Rockwell Automation 294D ArmorStart LT Distributed Motor Controller DeviceNet Version - User Manual - Manual (Page 109)

Rockwell Automation Publication 290D-UM001A-EN-P - June 2012 109
Bulletin 290D/291D/294D Programmable Parameters Chapter 4
ULWarningLevel
This parameter determines the
Underload Warning Level as a
percentage of Full Load Amps.
Parameter Number 79
Access Rule GET
Data Type USINT
Group Advanced Config.
Units %FLA
Minimum Value 10
Maximum Value 100
Default Value 70
OptionMatch
If product options do not match value, a
hardware fault will occur.
Parameter Number 92
Access Rule GET/SET
Data Type DWORD
Group Advance Config
Units –
Minimum Value 0
Maximum Value 0xffffffff
Default Value 0
Bit
Function
4-31 3 2 1 0
— — — — X KeypadPreesent
— — — X — KeypadNotPresent
— — X — — BrakePresent
— X — — — BrakeNotPresent
X — — — — Reserved
AutobaudEnable
Autobaud enabled when set
0=Disable
1=Enable
Parameter Number 100
Access Rule SET
Data Type BOOL
Group Network
Units –
Minimum Value 0
Maximum Value 1
Default Value 1