Toshiba Magnia Z500 - Manual (Page 91)

Installing and Removing Hardware
Memory module
72
Removing a memory module
Before removing a memory module, carefully read “Before start-
ing operation” on page 46 and proceed to the job following the
procedure mentioned below:
1 If the server is in operation, shut it down and switch off power.
2 Unplug the power cable from the AC outlet.
NOTE: Removing a memory module while the server is still
on could cause damage to the server and/or the memory
module.
3 Remove the server panels from the server.
See “Removing and replacing the server panels” on page 52.
4 Extend the hooks on both sides of the memory slot outwards
and remove the memory module out of the slot.
When the hooks of the memory slot are extended outwards,
the memory module occasionally springs out of the slot. Be
sure to hold the memory module by hand through the remov-
ing work.
Removing a memory module
5 Fit the server panels to the server.