5 is the power indicator () lit amber, Characters are distorted or not displayed properly – Toshiba Magnia Z500 User Manual
Page 211
Troubleshooting
Troubleshooting
194
4 Are the power cables for the server and display unit properly
connected to a grounded AC outlet?
See “Connecting the power cable” on page 36.
5 Is the power indicator (
) lit amber?
6 Turn the display unit on, and set the brightness and contrast to
two thirds of the maximum value or more.
See the operating manual of the display unit.
7 When running Windows 2000, boot up in the VGA mode, and
make sure that the settings (resolution, synchronising fre-
quency) are as supported by the display unit.
Characters are distorted or not displayed properly
Probable causes are faulty connection of the display signal cable
or power cable, or a problem with the brightness or contrast set-
tings. Carry out the following procedure to check the cause of the
trouble. If this does not remedy the problem, see “Remedy When
Windows 2000 is Unusable” on page 201.
1 Is the display unit properly connected to the server?
If the switch box is used on a Rack Type, also check the con-
nections with other devices and that the server is properly
selected.
See “How to connect peripheral devices” on page 27.
2 Turn the display unit on, and set the brightness and contrast to
two thirds of the maximum value or more.
See the operating manual of the display unit.
3 When running Windows 2000, boot up in the VGA mode, and
make sure that the settings (resolution, synchronising fre-
quency) are as supported by the display unit.